Address 2 characters Specifies the address defined for
hexadecimal the secondary Station. The default
is 40.
Group 2 characters Specifies the group poll address for
Address hexadecimal this Station. A value of 0 indicates
that the Station is not in a group.
The default value is 0.
Transfer twa | tws Specifies the link level transmit/-
Mode receive capability of the Station.
The default is twa. TWA is Two Way
Alternate; TWS is Two Way
Simultaneous.
Modulo normal | Specifies that the Station supports
extended normal response mode (window size
ranges from 1 to 7) or normal
response mode extended (window
size ranges from 1 to 127). This
attribute is ignored for connections
that perform XID3 negotiation. The
default is normal.
Window Size (1-127) Specifies the maximum number of
received I-frames that may be
outstanding before this station
requires an acknowledgment response.
This value allows for the detection
of erroneous sequence numbers in
received frames. The default is 7.
Send Frame (1-32764) Specifies the maximum frame size
Size (excluding the header) this Station
can send. This value may be reduced
during preconnection XID
negotiation or by the Station's
client. The default is 265.
Inactivity (0-7200) Specifies the time (in seconds) to
Timer wait for a command before initiating
recovery action. This is used when
the Link is secondary. The default
is 30.
Pass Limit (1-254) Specifies the maximum number of
BLUs that can be sent to the second-
ary Station before starting data
transmission to the next Station in
the Link Service Order Table. This is
used when the Link is primary. The
default is 1. Not used at this time.
Select (1-60000) Specifies the time (in milliseconds)
Pause to pause before sending a response
with the final bit set. This is used
when the Link is secondary. The
default is 50.
Retry (0-255) Specifies the time (in seconds) to
Sequence pause after completing a retry
Pause sequence before beginning a new retry
sequence. This is used when the
Link is primary. The default is 0.
Not used at this time.
Retry (0-127) Specifies the maximum number of
Sequence retry sequences allowed. This is
Limit used when the Link is primary. The
default is 0. Not used at this time.
Immediate no | yes Specifies whether a Station
Poll subentity will be repolled when there
Retry is a reply time-out before proceeding
to next Station on the Link's Service
Order Table. The default is no. Not
used at this time.