Address 2 characters Specifies the address defined for the
hexadecimal secondary Station. You can set this
attribute only when the Station is
disabled. The default is 40.
Group 2 characters Specifies the group poll address
Address hexadecimal for this Station. A value of 0
indicates that the Station is not in
a group. The default value is 0.
Transfer twa | tws Specifies the link level transmit/-
Mode receive capability of the Station.
The default is twa. TWA is Two Way
Alternate; TWS is Two Way
Simultaneous. This attribute is
settable only when the Station is
disabled.
Modulo normal | Specifies that the Station supports
extended normal response mode (window size
ranges from 1 to 7) or normal
response mode extended (window
size ranges from 1 to 127). This
attribute is ignored for connections
that perform XID3 negotiation. The
default is normal. This attribute is
settable only when the Station is
disabled.
Window Size (1-127) Specifies the maximum number of
received I-frames that may be
outstanding before this station
requires an acknowledgment response.
This value allows for the detection
of erroneous sequence numbers in
received frames. This attribute is
settable only when the Station is
disabled. The default is 7.
Send Frame (1-32764) Specifies the maximum frame size
Size (excluding the header) this Station
can send. This value may be reduced
during pre-connection XID
negotiation or by the Station's
client. This attribute is settable
only when the Station is disabled.
The default is 265.
Inactivity (0-7200) Specifies the time (in seconds) to
Timer wait for a command before initiating
recovery action. This is used when
the Link is secondary. The default is
30. This attribute is settable only
when the Station is disabled.
Pass Limit (1-254) Specifies the maximum number of
BLUs that can be sent to the second-
ary Station before starting data
transmission to the next Station in
the Link service order table. This is
used when the Link is primary. The
default is 1. This attribute is
settable only when the Station is
disabled. Not used at this time.
Select (1-60000) Specifies the time (in milliseconds)
Pause to pause before sending a response
with the final bit set. This is used
when the Link is secondary. The
default is 50.
Retry (0-255) Specifies the time (in seconds) to
Sequence pause after completing a retry
Pause sequence before beginning a new retry
sequence. This is used when the
Link is primary. The default is 0.
Not used at this time.
Retry (0-127) Specifies the maximum number of
Sequence retry sequences allowed. This is used
Limit when the Link is primary. The default
is 0. This attribute is settable only
when the Station is disabled. Not
used at this time.
Immediate no | yes Specifies whether a Station subentity
Poll will be repolled when there is a
Retry reply time-out before proceeding to
the next Station on the Link's
service order table. This attribute
is settable only when the Station is
disabled. The default is no. Not
used at this time.