Address 2 characters Displays the address of the
hexadecimal secondary Station. The default is
40.
Group 2 characters Displays the group poll address for
Address hexadecimal Station. A value of 0 indicates the
Station is not in a group. The
default value is 0.
Transfer twa | tws Displays the link level transmit/-
Mode receive capability of the Station.
The default is twa. TWA is Two Way
Alternate; TWS is Two Way
Simultaneous.
Modulo normal | Displays whether the Station
extended supports normal response mode
(window size ranges from 1 to
7) or normal response mode
extended (window size ranges from 1
to 127). This attribute is ignored
for connections that perform XID3
negotiation. The default is normal.
Window Size (1-127) Displays the maximum number of
received I-frames that may be
outstanding before this station
requires an acknowledgment response.
This value allows for the detection
of erroneous sequence numbers in
received frames. The default is 7.
Send Frame (1-32764) Displays the maximum frame size
Size (excluding the header) this Station
can send. This value may be reduced
during pre-connection XID
negotiation or by the Station's
client. The default is 265.
Inactivity (0-7200) Displays the time (in seconds) to
Timer wait for a command before initiating
recovery action. This is used when
the Link is secondary. The default is
30.
Pass Limit (1-254) Displays the maximum number of
BLUs that can be sent to the second-
ary Station before starting data
transmission to the next Station in
the Link service order table. This is
used when the Link is Primary. The
default is 1.
Select (1-60000) Displays time (in milliseconds) to
Pause pause before sending a response with
the final bit set. This is used when
the LINK is secondary. The default
is 50.
Retry (0-255) Displays the time (in seconds) to
Sequence pause after completing a retry sequ-
Pause ence before beginning a new retry
sequence. This is used when the
Link is primary. The default is 0.
Not used at this time.
Retry (0-127) Displays the maximum number of
Sequence retry sequences allowed. This is used
Limit when the Link is primary. The
default is 0. Not used at this time.
Immediate no | yes Displays whether a Station
Poll subentity will be repolled when there
Retry is a reply time-out before proceeding
to next Station on the Link's service
order table. The default is no.