Use the SHOW MODULE X25-ACCESS command to display the parameters of
 the Access Module from the volatile data base.  Use the LIST MODULE
 X25-ACCESS command to display the Access Module parameters  stored
 in the permanent data base.

     SHOW  MODULE X25-ACCESS     CHARACTERISTICS TO file-id
     LIST                        STATUS
                                 SUMMARY

                                 NETWORK network-name CHARACTERISTICS TO file-id
                                 KNOWN NETWORKS       STATUS
                                                      SUMMARY

 All underscores found in parameters must be replaced with spaces
 when parameters are used in NCP commands.

1  –  CHARACTERISTICS

 Displays static line information.

2  –  NETWORK name

 Displays information for the specified network only.

3  –  KNOWN NETWORKS

 Displays information for all known networks.

4  –  STATUS

 Displays dynamic module information. (Used only with the SHOW MODULE
 X25-ACCESS command.)

5  –  SUMMARY

 Displays only the most useful module information.  This is the
 default display type.

6  –  TO file-id

 Specifies the output file. If you omit this parameter, the default
 file is SYS$OUTPUT.