Use the SHOW MODULE X25-PROTOCOL command to display the parameters  of
 the  Protocol Module from the volatile data base.  Use the LIST MODULE
 X25-PROTOCOL command to display the Protocol Module parameters  stored
 in the permanent data base.

 Format:

    SHOW  MODULE X25-PROTOCOL     CHARACTERISTICS
    LIST                          COUNTERS
                                  STATUS
                                  SUMMARY
                                  TO file-spec

                                  DTE dte-address  NETWORK net-name
                                  KNOWN DTES       KNOWN NETWORKS

                                  GROUP groupname
                                  KNOWN GROUPS

                                  NETWORK network-name
                                  KNOWN NETWORKS

 All underscores found in parameters must be replaced with spaces
 when parameters are used in NCP commands.

1  –  CHARACTERISTICS

 Displays static line information.

2  –  COUNTERS

 Displays DTE error and performance statistics.  (Used only with the
 SHOW MODULE X25-PROTOCOL command.)

3  –  DTE dte-address

 Displays information for the specified DTE only.

4  –  GROUP name

 Displays information for the specified group only.

5  –  KNOWN

5.1  –  DTES

 Displays information for all known DTEs.

5.2  –  GROUPS

 Displays information for all known groups.

6  –  STATUS

 Displays dynamic module information.  (Used only with the SHOW
 MODULE X25-PROTOCOL command.)

7  –  SUMMARY

 Displays only the most useful module information.  This is the
 default display type.

8  –  TO file-id

 Specifies the output file.  If you omit this parameter, the default
 file is SYS$OUTPUT.