TCPIP$UCP_HELP.HLB  —  START

1  –  MAIL 

    Manually starts the SMTP sender queues (not the receiver
    [server]).

    Related commands: SHOW MAIL, ENABLE SERVICE SMTP, SHOW
    CONFIGURATION SMTP

    Format

      START MAIL

1.1  –  Restrictions 

    Requires SYSPRV or BYPASS privilege.

    SMTP consists of the sender and the receiver. Start the sender
    before you enable the receiver.

    Do not issue this command unless SMTP has been configured (with
    the SET CONFIGURATION SMTP command).

1.2  –  Examples 

    1.TCPIP> START MAIL

      Starts the SMTP sender.

      (To start the SMTP sender when TCP/IP Services starts up, see
      the SET CONFIGURATION ENABLE_SERVICE command. To start the SMTP
      receiver, see the ENABLE SERVICE command.)

2  –  ROUTING 

    Starts dynamic routing with ROUTED or GATED. If you want to
    change from one to the other, you must stop the current dynamic
    routing daemon then start the desired daemon. You cannot run both
    GATED and ROUTED at the same time.

    Related commands: STOP ROUTING, SET GATED

    Format

      START ROUTING  [/GATED ]

                     [ /LOG ]

                     [ /SUPPLY[=DEFAULT] ]

2.1  –  Qualifiers

2.1.1    /GATED 

    Optional.

    Enables the gateway routing daemon (GATED).

    If you enable dynamic GATED routing, you will be able to
    configure this host to use any combination of the following
    routing protocols to exchange dynamic routing information with
    other hosts on the network:

    o  RIP (Routing Information Protocol), Versions 1 and 2

    o  RDISC (Router Discovery Protocol)

    o  OSPF (Open Shortest Path First)

    o  EGP (Exterior Gateway Protocol)

    o  BGP (Border Gateway Protocol), BGP-4

    o  Static routes

2.1.2    /SUPPLY 

       /SUPPLY[=DEFAULT]

    Optional. Applies only to ROUTED. Do not use with /GATED.

    Broadcasts routing information to other hosts in 30-second
    intervals.

    If you specify /SUPPLY=DEFAULT, the local host supplies the
    default network route.

2.1.3    /LOG 

    Optional. Applies to ROUTED. Do not use with /GATED.

    Logs routing activity to
    SYS$SYSDEVICE:[TCPIP$ROUTED]TCPIP$ROUTED.LOG.

    Default: No logging.

2.2  –  Examples 

    1.TCPIP> START ROUTING /GATED

      Starts GATED dynamic routing on the running system.

    2.TCPIP> START ROUTING

      Interactively starts ROUTED dynamic routing on the running
      system.

    3.TCPIP> START ROUTING /SUPPLY

      Immediately starts ROUTED dynamic routing. The local host both
      broadcasts and receives network routing information.
Close Help